Hi, I have buyed 3 Aironet 1142n AP, where is described that are 802.11n compliant. But there is no way to configure a Data Rates more than 54.0Mb/sec.. so only 802.11g. In the configuration this is the max speed allowed. I really don't understant why. The network interface configurable are 2, 1 interface Radio0-802.11n 2.4Ghz and Radio1 802.11N 5Ghz but both only to 54Mb/sec maximal Data rates speed!! Someone can help me?
You will not see more than 54 Mbps on the data rates. It's the MCS rates that you need to look at.
The max you will see in the 2.4 is 145mbps. On the 5ghz, you can get up to 300mbps. You need to make sure you either use open authentication or wpa2/aes, which is an 802.11n standard. WMM needs to be enabled and the channel width on the 5ghz must be set to 40mhz.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...