Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Aironet 1242AG Information

     I'm currently trying to set up a wireless repeater for use in the warehouse section of a business site.  However, due to the AP being hidden/unbroadcasted, I need to get various bits of information from the setup page of the AP device.  While I was able to get most of it (SSID, type of security/encryption, etc.), I can't seem to find information about what channel the AP uses anywheres.  I would appreciate any information I could get that would point me in the right direction.  Thanks!

Everyone's tags (2)
4 REPLIES

Cisco Aironet 1242AG Information

Hall of Fame Super Silver

Re: Cisco Aironet 1242AG Information

Try these commands:

show controllers dot11radio 0
show controllers dot11radio 1

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
New Member

Cisco Aironet 1242AG Information

I'd have to ask, what standard do these commands follow?  Are these commands for a telnet, cmd, etc.?

Gold

Cisco Aironet 1242AG Information

Hi Jordan,

You can telnet to the AP and issue above commands. Also you could try this from access point console through hyper terminal.

You should be able to see some output like below and you will have to consentrate on the bold letters for the information you want

1242#show controllers dot11radio 0

!

interface Dot11Radio0

Radio AIR-AP1242GR, Base Address 0023.ab27.3210, BBlock version 0.00, Software version 6.20.2

Serial number: GAM12412478

Number of supported simultaneous BSSID on Dot11Radio0: 16

Carrier Set: EMEA (EU) (-E)

Uniform Spreading Required: No

Current Frequency: 2437 MHz Channel 6

Allowed Frequencies: 2412(1) 2417(2) 2422(3) 2427(4) 2432(5) 2437(6) 2442(7) 2447(8) 2452(9) 2457(10) 2462(11) 2467(12) 2472(13)

Listen Frequencies: 2412(1) 2417(2) 2422(3) 2427(4) 2432(5) 2437(6) 2442(7) 2447(8) 2452(9) 2457(10) 2462(11) 2467(12) 2472(13) 2484(14)

Beacon Flags: 0; Beacons are enabled; Probes are enabled

High Density mode disabled

Local Rx sensitivity (Config -127, Max -60, Min -11, Active -60) dBm

CCA Sensitivity -64 dBm

Cell Rx sensitivity -80 dBm, CCA Sensitivity -60 dBm,

Current CCK Power: 17 dBm

Current OFDM Power: 17 dBm

Active CCK Power: 17 dBm

Active OFDM Power: 17 dBm

Active OFDM-24 Power: 17 dBm

Active OFDM-36 Power: 17 dBm

Active OFDM-48 Power: 17 dBm

Active OFDM-54 Power: 17 dBm

Active OffChnl Power: 17, Rate 1.0

Allowed CCK Power Levels: -1 2 5 8 11 14 17

Allowed OFDM Power Levels: -1 2 5 8 11 14 17

Allowed Client Power Levels: 2 5 8 11 14 17

Receive Antennas : right left

Transmit Antennas : right left

Antenna: external, Gain: Allowed 4, Reported 4, In Use 4

Active Rates: basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

Current Rates: basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

Allowed Rates: 1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0

All Rates: 1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0

Default Rates: basic-1.0 basic-2.0 basic-5.5 basic-11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0

Best Range Rates: basic-1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0

Best Throughput Rates: basic-1.0 basic-2.0 basic-5.5 basic-11.0 basic-6.0 basic-9.0 basic-12.0 basic-18.0 basic-24.0 basic-36.0 basic-48.0 basic-54.0

Current Voice Rates: basic-5.5 basic-11.0 6.0 12.0 24.0 [disabled until voice packet-discard enabled]

Default Voice Rates: basic-5.5 basic-11.0 6.0 12.0 24.0

Channel Range Max Power CCK 18 24 36 48 54 Allowed Levels

1 to 13 by 1 17 17 17 17 17 17 -1 2 5 8 11 14 17

Data Rate Sensitivity (rate, SNR dB, Contention dBm)

( 1.0, 10, -93) ( 2.0, 10, -92) ( 5.5, 11, -90) (11.0, 14, -90)

( 6.0, 15, -89) ( 9.0, 16, -88) (12.0, 18, -88) (18.0, 19, -86)

(24.0, 20, -85) (36.0, 24, -81) (48.0, 27, -78) (54.0, 31, -77)

ERP settings: short slot time.

Hope that helps.

Regards

Najaf

Please rate when applicable or helpful !!!

592
Views
0
Helpful
4
Replies