10-28-2014 07:44 AM - edited 07-05-2021 01:49 AM
Dear Cisco Support Community
i have a problem on one of my 1310 wireless bridge it is stucked on flash memory test and after resetting the baudrate to 115200
all i see on the bridge is status and Ethernet Leds are blinking green.
Can you please help me?
10-28-2014 09:56 PM
During access point operation the LEDs provide status information as shown in Table 5-1.
Message type | Ethernet LED | Status LED | Radio LED | Meaning |
---|---|---|---|---|
Boot loader status | Green | - | Green | DRAM memory test. |
- | Amber | Red | Board initialization test | |
- | Blinking green | Blinking green | Flash memory test. | |
Amber | Green | - | Ethernet initialization test. | |
Green | Green | Green | Starting Cisco IOS. | |
Association status | - | Green | - | At least one wireless client device is associated with the unit. |
- | Blinking green | - | No client devices are associated; check the unit's SSID and WEP settings. | |
Operating status | - | Green | Blinking green | Transmitting/receiving radio packets. |
Green | - | - | Ethernet link is operational. | |
Blinking green | - | - | Transmitting/receiving Ethernet packets. | |
Boot loader errors | Red | - | Red | DRAM memory test failure. |
- | Red | Red | File system failure. | |
Red | Red | - | Ethernet failure during image recovery. | |
Amber | Green | Amber | Boot environment error. | |
Red | Green | Red | No Cisco IOS image file. | |
Amber | Amber | Amber | Boot failure. | |
Operation errors | - | Green | Blinking amber | Maximum retries or buffer full occurred on the radio. |
Blinking amber | - | - | Transmit/receive Ethernet errors. | |
- | Blinking amber | - | General warning. | |
Configuration reset | - | Amber | - | Resetting the configuration options to factory defaults. |
Failure | Red | Red | Red | Firmware failure; try disconnecting and reconnecting unit power. |
Firmware upgrade | - | Red | - | Loading new firmware image. |
Controller status | Alternating green, red, and amber1 | Connecting to the controller. Note If the access point remains in this mode for more than five minutes, the access point is unable to find the controller. Ensure a DHCP server is available or that controller information is configured on the access point. | ||
Message type | Ethernet LED | Status LED | Radio LED | Meaning |
1 This status indication has the highest priority and overrides other status indications.
10-29-2014 02:02 AM
and for this reason i am stucked. On the CLI there is Unknown character i cant login to the bridge any help on how i can login to the CLI will be appreciated
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: