Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Aironet 1310 flash memory test

Dear Cisco Support Community 

i have a problem on one of my 1310 wireless bridge it is stucked on flash memory test and after resetting the baudrate to 115200

all i see on the bridge is status and Ethernet Leds are blinking green. 

Can you please help me?

 

 

2 REPLIES

LED IndicationsDuring access

LED Indications

During access point operation the LEDs provide status information as shown in Table 5-1.

 

Table 5-1 LED Signals 

Message
type
Ethernet
LED
Status
LED
Radio
LED
Meaning

Boot loader status

Green

-

Green

DRAM memory test.

-

Amber

Red

Board initialization test

-

Blinking green

Blinking green

Flash memory test.

Amber

Green

-

Ethernet initialization test.

Green

Green

Green

Starting Cisco IOS.

Association status

-

Green

-

At least one wireless client device is associated with the unit.

-

Blinking green

-

No client devices are associated; check the unit's SSID and WEP settings.

Operating status

-

Green

Blinking green

Transmitting/receiving radio packets.

Green

-

-

Ethernet link is operational.

Blinking green

-

-

Transmitting/receiving Ethernet packets.

Boot loader errors

Red

-

Red

DRAM memory test failure.

-

Red

Red

File system failure.

Red

Red

-

Ethernet failure during image recovery.

Amber

Green

Amber

Boot environment error.

Red

Green

Red

No Cisco IOS image file.

Amber

Amber

Amber

Boot failure.

Operation errors

-

Green

Blinking amber

Maximum retries or buffer full occurred on the radio.

Blinking amber

-

-

Transmit/receive Ethernet errors.

-

Blinking amber

-

General warning.

Configuration reset

-

Amber

-

Resetting the configuration options to factory defaults.

Failure

Red

Red

Red

Firmware failure; try disconnecting and reconnecting unit power.

Firmware upgrade

-

Red

-

Loading new firmware image.

Controller status

Alternating green, red, and amber1

Connecting to the controller.

Note If the access point remains in this mode for more than five minutes, the access point is unable to find the controller. Ensure a DHCP server is available or that controller information is configured on the access point.

Message
type
Ethernet
LED
Status
LED
Radio
LED
Meaning

1 This status indication has the highest priority and overrides other status indications.

New Member

and for this reason i am

and for this reason i am stucked. On the CLI there is Unknown character i cant login to the bridge any help on how i can login to the CLI will be appreciated

59
Views
10
Helpful
2
Replies