In the meantime is it possible to set one of these access points up in the same way a netgear type home wireless router works?
Your Netgear is a two-in-one: You have a router and with an embedded wireless access point.
Your 802.11 a/b/g, either an 1130 or a 1240, is just a plain wireless access point. Cisco has three routers which are routers and have embedded wireless access point (only one is 802.11 a/b/g/n but the other two are only 802.11 b/g).
If you want to run NAT, you need to have a router to do the NAT-ing. The wireless access point, as what others have pointed out, is just a plain Layer 2 device.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...