We have 2 Cisco Aironet Power Injector LR2's (AIR-PWRINJ-BLR2=) and I can't console to either using Cisco sky blue consoel cable.
I am using putty and my setting are:
Speed = 9600
Data Bits = 8
Stop Bits = 1
parity = none
Flow control = none
I don't believe you can console into a power injector. Why, if I should ask, are you doing this?
How do I configure the 1301 that connects to it via coaxial and why does the LR2 have a console port in the first place?
Under Network Management
The power injector does not require configuration or management.
Cisco Aironet 1300 Series Access Point/Bridge Power Injector
Go to the website posted below. Choose from either Configuration Examples & TechNotes or Configuration Guides.
Hope this helps and please don't forget to rate our posts. Thanks.
Console Cable is ok
I'm not talking about the console cable. The ethernet cable from the injector to the WAP could be faulty.