Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco Aironet

Hi,

I have just purchased a second hand Cisco Aironet wireless accesspoint AIR-AP1232AG-N-K9 which was already configured. Global Configuration mode can't be accessed. For example there is a hostname configured but when I try changing the hostname but doesn't work (check the screenshot attached)

Also when I connect into my router it also get an ip address from the dhcp but I cannot connect from the GUI (via a browser) for the cisco interface.

I tried resetting to factory defaults, it just resetted but the hostname never changed.

Any suggestions please ?

untitled.JPG

Everyone's tags (3)
2 REPLIES
Hall of Fame Super Silver

Re: Cisco Aironet

Try issuing write erase and then reload without saving. Here is a thread that might help.

https://supportforums.cisco.com/thread/340649

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: Cisco Aironet

The AP might be lightweight. See if it take this command: test capwap or test . Also you can issue a show version and if the boot image has k9w8 it's lightweight and if it's k9w7 it's IOS. I the ap is lightweight, you will need to convert it to autonomous.

Look at this thread

https://supportforums.cisco.com/thread/2006044

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
247
Views
0
Helpful
2
Replies
CreatePlease to create content