I have several Cisco APs 1141 in a Wireless Lan Controller 5508 with the 7.2 version.
The APs are registered correctly in the WLC, but when I want to change the AP Mode to "Bridge", the WLC shows an error message as this: "This mode not is supported in this model device AP"
Although the 1140 series APs support the bridge mode, I don´t understand why in the WLC I can´t configure the AP in that mode. I have read several documents of Cisco support and I haven't found nothing about this issue. And all of them write that APs 1140 support the Bridge mode.
Is there any problem with the WLC version? Is there any limitation with this AP model in mode centralized?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...