Cisco AP 1240AG series Fast Ethernet cannot up

[Tang-Suan Tan]

Hi all :

My question here is how is the IP configuration for this Fast Ethernet F0.

This is because usually we only assign IP to the BVI interface. Is it after that, the Fast Ethernet F0 automatically also be assigned the same IP?

As such, when goto the Fast Ethernet F0 by CLI, by using no shut then this will Enable the Fast Ethernet Port?

Thanks!

Best regards,

tangsuan

[Scott Fella]

Assign it to the BVI interface and do a no shut.

Thanks,

Scott Fella

Sent from my iPhone

[Tang-Suan Tan]

Hi Scott :

Thanks for your reply!

I will try and let you know the result.

Best regard,

tangsuan

[Scott Fella · Accepted solution]

This might help

http://www.scribd.com/doc/47358854/1242-Configuration-guide

Thanks,

Scott Fella

Sent from my iPhone

[Tang-Suan Tan]

Hi Scott :

The problem is due to the patch line not connect up somewhere. After connect the line up, now the Optical Ethernet line is up.

Thanks for your help on this.

regards,

tangsuan