Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco AP 1242AG Config Got Hosed

I have an AP that was LWAPP on a WLC but during an upgrade it is one the got hosed.  When it boots up, it just stops and shows Red lights.  I have consoled into it and it will start to boot and then give Error loading "Flash:/update/c1240-k9w8-mx.124-18a.JA2/c1240-k9w8-mx.124-18a.JA2.

Interrupt within 5 seconds to abort boot process

boot process failed...

The system is unable to boot automatically.  The BOOT environment needs to be set to a bootable image.

ap:

Well, I have a new image, but my question is how do I get this into the AP with the console cable.  Do I use xmodem or something like that.  Once the AP goes to the point where it shows ap:  then it is stopped.  There is no typing or anything that will work.  Anyone have a link that explains how to put code into an AP with a bad boot image or can you explain how to do this.  I would surely appreciate it.

Thankyou,

Joe

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Cisco AP 1242AG Config Got Hosed

Using a TFTP Server to Return to a Previous Release

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918

Please don't forget to rate our useful posts.  Thanks.

3 REPLIES
Hall of Fame Super Gold

Re: Cisco AP 1242AG Config Got Hosed

Using a TFTP Server to Return to a Previous Release

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918

Please don't forget to rate our useful posts.  Thanks.

Community Member

Re: Cisco AP 1242AG Config Got Hosed

Thank you!!!! I just love you all (in a respectful way, of course)!!!!!

Hall of Fame Super Gold

Re: Cisco AP 1242AG Config Got Hosed

Thank you very much for the ratings.  Glad to be of some form of assistance. 

1066
Views
0
Helpful
3
Replies
CreatePlease to create content