Cisco AP LED Status

[bouchal-38]

Hello,

I would like to know if someone can tell me what means the LED status?

When it is blinkink, or OFF?

Rightnow, i have the LED OFF, bur the SSID is working, the broadcast is working...

What does it mean?

Tx,

B.

[Scott Fella]

You can enable and disable the LED on an access point if you want. Here is a link and most likely why your AP works but is in a disabled state. I'm assuming it's a lightweight AP

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010000001.html

Sent from Cisco Technical Support iPhone App

[Scott Fella]

For autonomous, the command is led display off or led display dim.

Sent from Cisco Technical Support iPhone App

[Victor Vasantha Kumar]

Hi ,

Please refer the following doc. for more information.

https://supportforums.cisco.com/docs/DOC-5377

Let us know if you are looking for anyting in particular ( any AP model)

Regards
Victor V

*****Help out other by using the rating system and marking answered questions as *****Answered"*****

[manassin]

Hi,

What is the model of the AP

Is it a Standalone AP or LWAP.

You can refer to the following link for the LED status:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1200/installation/guide/1200-TD-Book-Wrapper/120h_7.html

Check table 7-1

It is for 1200 series AP.

Please let me know the exact model of your AP.

Thanks and regards,

Manas Pratap Singh