I have used the AIR-AP2800-K9-ME-8-3-112-0.zip package to update Cisco my wireless access points (AIR-AP2802i-E-K9). Of my three APs, two succeeded but one failed and is unable to boot - error message attached. Please can anyone assist with the recovery procedure or options to replace or repair the BootROM? I have tried to hold down the mode button during power up but I am not getting any further than the error message indicates. Is booting from USB an option perhaps? Any help would be appreciated. Thank you.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...