Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco AP1552 is in bridge mode and want it in H-REAP mode

Hi,

I've recently installed a Cisco AP1552E and have got as far as it registering on the WLC2504 (V7.0.116). However, when I go to the Wireless --> General Tab its shows the AP Mode as Bridge. There are no options to change it to HREAP or anything else. I've seen other posts that make me think the AP should support HREAP but can't find a way of changing it. Any sugesstions?

Regards

Mark                  

4 REPLIES
Hall of Fame Super Silver

Re: Cisco AP1552 is in bridge mode and want it in H-REAP mode

That's because it wasn't supported until v7.3 or v7.4.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: Cisco AP1552 is in bridge mode and want it in H-REAP mode

v7.2.110.0 is when that was supported.

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn7_2_110_0.html#wp784178

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
New Member

Cisco AP1552 is in bridge mode and want it in H-REAP mode

Ok thanks very much Scott, I thought that AP was supported in 7.0.116, but I have some 1602E's which I think need the latest 7.4 software too.

Many thanks

Hall of Fame Super Silver

Cisco AP1552 is in bridge mode and want it in H-REAP mode

No problem... can you mark the question answered.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
196
Views
5
Helpful
4
Replies