Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco's 7500 series WLC for Branch Office Management

Hi , i would like to use Cisco's 7500 series WLC in my office to control all my branch office's accesspoints ( nearly 500 AP' ).

How many accesspoints will this 7500 WLC supports per single branch office

& what about the data traffic / controll traffic information flow from clinet to WLC.

how much bandwidth required between AP to WLC for remote WAN traffic per AP.

4 REPLIES
Cisco Employee

Re: Cisco's 7500 series WLC for Branch Office Management

Hello,

This may answer some of your questions

7500 deployment guide

http://www.cisco.com/en/US/products/ps11635/products_tech_note09186a0080b7f141.shtml


Sent from Cisco Technical Support iPhone App

Silver

Re: Cisco's 7500 series WLC for Branch Office Management

Cisco Employee

Re: Cisco's 7500 series WLC for Branch Office Management

Havinder,

its the same link that was posted above. maybe you didnt pay attention.

thanks,

Cisco Employee

Re: Cisco's 7500 series WLC for Branch Office Management

FlexConnect APs are deployed at the Branch site and managed from the       Data Center over a WAN link. It is highly recommended that the minimum       bandwidth restriction remains 12.8 kbps per AP with the round trip latency no       greater than 300 ms for data deployments and 100 ms for data + voice       deployments. The maximum transmission unit (MTU) must be at least 500       bytes.

Deployment Type WAN Bandwidth                   (Min) WAN RTT Latency                   (Max) Max APs per Branch Max Clients per Branch
Data64 kbps300 ms525
Data + Voice128 kbps100 ms525
Monitor64 kbps2 sec5N/A
Data640 kbps300 ms501000
Data + Voice1.44 Mbps100 ms501000
Monitor640 kbps2 sec50N/A
224
Views
5
Helpful
4
Replies