Cisco's 7500 series WLC for Branch Office Management

[selvaaaaa]

Hi , i would like to use Cisco's 7500 series WLC in my office to control all my branch office's accesspoints ( nearly 500 AP' ).

How many accesspoints will this 7500 WLC supports per single branch office

& what about the data traffic / controll traffic information flow from clinet to WLC.

how much bandwidth required between AP to WLC for remote WAN traffic per AP.

[Viten Patel]

Hello,

This may answer some of your questions

7500 deployment guide

http://www.cisco.com/en/US/products/ps11635/products_tech_note09186a0080b7f141.shtml


Sent from Cisco Technical Support iPhone App

[harvisin]

HEllo,

The Link below might help you out:-

http://www.cisco.com/en/US/products/ps11635/products_tech_note09186a0080b7f141.shtml

[Viten Patel]

Havinder,

its the same link that was posted above. maybe you didnt pay attention.

thanks,

[Ravi Singh]

FlexConnect APs are deployed at the Branch site and managed from the       Data Center over a WAN link. It is highly recommended that the minimum       bandwidth restriction remains 12.8 kbps per AP with the round trip latency no       greater than 300 ms for data deployments and 100 ms for data + voice       deployments. The maximum transmission unit (MTU) must be at least 500       bytes.

Deployment Type	WAN Bandwidth                   (Min)	WAN RTT Latency                   (Max)	Max APs per Branch	Max Clients per Branch
Data	64 kbps	300 ms	5	25
Data + Voice	128 kbps	100 ms	5	25
Monitor	64 kbps	2 sec	5	N/A
Data	640 kbps	300 ms	50	1000
Data + Voice	1.44 Mbps	100 ms	50	1000
Monitor	640 kbps	2 sec	50	N/A