Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco SAP2602e with Motorola scannersystem

Hi,

Since 1242 went EOS we've moved to SAP2602e, but we are facing a problem with this and Motorola MK4000 and MC17 barcode scanner system. At the moment we are mainly focusing on the MK4000. It keeps loosing its connection to the WiFi at times that look random. We see that we loose ping to them. But I can still see it in show dot11 association and it keeps updating the Activity timer until it reboots and then gets network connection again.

We are running on 2.4GHz, have tired changeing power level, channel, long and short preamble, turned off .11b and .11n.

I am not sure what else to try. Any help is appreciated.

Regards,

Philip

9 REPLIES
Hall of Fame Super Silver

Re: Cisco SAP2602e with Motorola scannersystem

Philip,

I would try to keep the config as close as possible to the original 1242. This will help identify what might be wrong.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: Cisco SAP2602e with Motorola scannersystem

Post your show run-config if you don't mid so we can look at it and give some suggestions. It would be nice to also see the 1242 config that worked so we can compare.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Cisco SAP2602e with Motorola scannersystem

I attached the config in the original post.

New Member

Pvilhelmsson, Did you ever

Pvilhelmsson,

 

Did you ever figure out this problem?  We've been chasing a Moto scan gun issue as well.  

Hi,We converted them to

Hi,

We converted them to CAPWAP (7.4.110) and moved to 5GHz. It has been running fine for months.

Regards,

Philip

Hall of Fame Super Gold

Cisco SAP2602e with Motorola scannersystem

What antenna is your AP using?

Cisco SAP2602e with Motorola scannersystem

AIR-ANT2524DW-R

Hall of Fame Super Gold

Cisco SAP2602e with Motorola scannersystem

And how many of these antennas are installed (per AP)?

Re: Cisco SAP2602e with Motorola scannersystem

We are using 4 per AP.

Sent from Cisco Technical Support iPhone App

325
Views
0
Helpful
9
Replies
CreatePlease login to create content