I'm trying to configure a 3com AP (8760)to carry different SSIDs on multiple vlans. The switchport is configured as a trunk (dot1q). Each virtual ap on the AP is configured with the correct vlan id. vlan support is enabled on the ap. The virtual ap which runs on the default vlan (vlan 1) works perfectly. Any others don't, if I look at the vlan table, it doesn't show anything other than vlan1 being active on the trunkport.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...