Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco WAP 4410N problem

Dear ,

We have setup Cisco WAP 4410N on our network two days back.

Before we setup this APs everything was going normal.We required to have a firewall so we setup two new WAP 4410N access points in the network.

Issue : After setting up this access points wireless devices are disconnecting from file server,sometimes taking too long time to connect to AP, file transfer rate is dead slow when compared to before and we cannot access web browser of AP1 when I am connected to AP1 but I can when I am connected through AP2 and Vice versa with AP2.

Both APs are same model,new, updated firmware and connected 14 devices to each AP.

Before all devices (both wired and wireless) used to depend on single wifi router, now all the device (wireless) depends on two APs.

 

Thanking You.

Everyone's tags (1)
18
Views
0
Helpful
0
Replies