I have been bought a Cisco AP WAP4410N in order to provide a wireless request. I have another AP with a different brand and I need to get an covered with the cisco but is not possible to get the cisco wired because there is not a wire available so I must use wireless connection with the AP.
In order to this what is the AP configuration in order to get my cisco AP connected with the other AP and my computers can connect to the cisco to get access?
I have been testing with this and i have some issue with it:
- I tested with WDS repeater and I configured the Mac addres of the other acces point and my computers can connect to the Cisco AP but they can connect to the network.
- I have test with Client/Repeater but the cisco AP doesn't show any signal and I just can see my other brand AP.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...