I am currently looking into reporting options for my Cisco WLC2125. From what I can see, I have two options, SNMP or Syslog however I would like to assign either Syslog or SNMP traffic via a specific port on the controller.
The reason is because i want to keep this traffic seperate to my wireless network.
My knowledge of controllers (and syslog and SNMP for that matter) but I can enter IP addresses for the servers however i cannot see how to assign this traffic to a specific port.
Re: Cisco WLC2125 Reporting Traps to a specific port
The traps will be sent from the management interface on the controller, so if your connectivity from WLC to switch is a trunk and your wireless networks are being handed off to a seperate vlan from your management vlan, you should be in good shape.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...