Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CLI command to show AP to the controller

We have just bought a 2100-controller for lab purposes. We were planning to run them independently of the rest of the network (i.e. only Controller and AP without contact with the regular DHCP-server) but how do I configure the AP so that it finds the controller?

I know that there is a way to use the CLI to but even though I have been looking I haven't found the right command.

2 REPLIES
Cisco Employee

Re: CLI command to show AP to the controller

if the APs are LWAPP then there is no extra commands.. The AP will join the controller automatically if the AP is getting the right IP address.

To check the number of APs on the controller we use "sh ap summary" command on the WLC CLI

Regards

Surendra

Hall of Fame Super Gold

Re: CLI command to show AP to the controller

how do I configure the AP so that it finds the controller

It's called "High Availability" 5.X, 6.X and 7.X firmware.

If you don't know what is your AP name, on the WLC, run the command "sh ap summary".

CLI command to use on the  WLC is "config ap primary-base ".

If you want the AP to join a controller, the command is "lwapp ap controller ip address ".

Please don't forget to rate our posts.  Thanks.

581
Views
0
Helpful
2
Replies