Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

command disabled

is there any default ip address for 1131ag access points? when i used CLI it showing that the command is desabled.......please help? the command which i gave in cli is #lwapp ap ip address 192.168.1.5 255.255.255.0

after this when i put enter it showing that the command is disabled..???

2 REPLIES
Hall of Fame Super Gold

Re: command disabled

Has the AP joined the controller yet? Run the "rcv" image.

New Member

Re: command disabled

See attached....

Serial attach to AP and follow instructions.

Little help file attached. This is how we reset aps back to factory. After performing IP assignment and controller. Connect back to network to get new image file.

141
Views
0
Helpful
2
Replies