Command to power-cycle all LWAP's on a controller

[Dylan Brereton]

Hi,

Is there a command to power cycle/reset ALL LWAP's on a controller at the same time? I see there is the reset command on the CLI but this is for specific AP's & not all AP's simultaneously.

(Cisco Controller) config>ap reset ?
               
<Cisco AP>     Enter the name of the Cisco AP.

[Leo Laohoo · Accepted solution]

You can "script" it.  I've done it before.  

Just copy and paste all your APs in a notepad and add the command in the start of the line.  

[Dylan Brereton]

Thanks Leo - Simple but effective.