Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Command to power-cycle all LWAP's on a controller

Hi,

Is there a command to power cycle/reset ALL LWAP's on a controller at the same time? I see there is the reset command on the CLI but this is for specific AP's & not all AP's simultaneously.

(Cisco Controller) config>ap reset ?
               
<Cisco AP>     Enter the name of the Cisco AP.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

You can "script" it.  I've

You can "script" it.  I've done it before.  

 

Just copy and paste all your APs in a notepad and add the command in the start of the line.  

2 REPLIES
Hall of Fame Super Gold

You can "script" it.  I've

You can "script" it.  I've done it before.  

 

Just copy and paste all your APs in a notepad and add the command in the start of the line.  

New Member

Thanks Leo - Simple but

Thanks Leo - Simple but effective.

15
Views
0
Helpful
2
Replies
CreatePlease to create content