Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

config groups for a redundant controller

Hello,

I have a primary controller that I configured without using WCS templates.

I am now adding a secondary controller that I will use only for redundant purposes and I would like to sync up the config from the primary.

I know that I can achieve this by using config groups but the problem is that I don't have any templates applied to the primary.

Is there any way to create/import templates based on the existing config of the primary? Then afterwards take those templates and apply them to the config group. Or do I need to manually configure new templates and then add them to the config group?

Thanks for your input,

Justin

2 REPLIES

config groups for a redundant controller

Not sure how to do with WCS, but you can upload ur configuration from WLC-1, change the IP address and the download to the WLC-2

Hall of Fame Super Silver

Re: config groups for a redundant controller

I agree... WCS will not push a full config and it's easier to do what nik mentioned.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
252
Views
0
Helpful
2
Replies