Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuration issue on 1231G AP

Hi,

I configured one vlan and trying to authenticate it through radius server.My objective is when a internal users want to connect through this SSID they just put username and password and authenticate through Radius server. Another vlan is getting authenticated through mac address that i need to manually put in AP.

Can any one please tell me where i ma making mistake.

Thanks
Saurabh

2 REPLIES

Configuration issue on 1231G AP

Hi Surabh,

bridge irb

You need to create  dot11 ssid

vlan x

vlan y

then  under interface radio 0/1 create subinterfaces

create encapsulation

bridge group command

similarly create on  gi 0  sub interfaces

create encapsulation

bridge group command

Bridge route ip

interface bvi ip address

ip default gateway

connect AP to switch port  configured as trunk

check  your aaa commands

radius server  shared secret  command is required

https://supportforums.cisco.com/docs/DOC-14496

check this document  link

and that should help you

-Srini

Configuration issue on 1231G AP

Saurabh:

You need to provide more informaiton about your problem:
- are you using autonomous or unified AP? (for now I think it is autonomous).
-  what do you exactly mean by users to provide username/password pairs? where should they enter those info?

- is there any eap type you want ot use? (PEAP, EAP-FAST...etc)?

Beside the link provided by Srini about configuring multiple SSIDs, Here is a link which a bit show configuring 802.1x security on the SSID:

http://tiny.cc/qrj8bw

Hope it will be useful.

Amjad

Rating useful replies is more useful than saying "Thank you"
348
Views
0
Helpful
2
Replies
CreatePlease login to create content