I am not expert in wireless and cisco. I need to configure accesspoint 1140 in my network. I have 10 vlans in my network (Switch 2960)
how i can configure accesspoint to used two ssid, one for lan and one for guest this two ssid in separate vlans. I was try like this...
i create vlans on 3750 switch. I connected my accesspoint to switch 2960 (2960 switch is enduser switch). I trunk the port on 2960 switch is connected to access point. I assign ip address to BVI Interface in accesspoint static. i am unable to ping from access point to other vlans, from other vlans to access point.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...