Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configure Aironet 2602i access points for stand alone operation

Hello,

 

I have two Cisco Aironet 2602i Access Points currently connected to a wireless controller. I would like to remove these from the controller and reconfigure the access points for stand alone operations. I have not done this before and would appreciate any help or advice you may give.

 

Thank you

2 REPLIES
New Member

Hello Drew,You have to

Hello Drew,

You have to download a standalone firmware and load it to the AP to convert it to autonomous mode. The standalone IOS has k9w7 on its file name while the LWAPP / CAPWAP version has k9w8. If you know how to upgrade a switch IOS of a 3750 switch then this should be no problem to you. It's the same procedure.

Thanks.

 

New Member

This might be easierhttp:/

This might be easier

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01101110.html

264
Views
0
Helpful
2
Replies