Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure LWAP for DCHP via console

I need to delete the static IP address and enable DHCP on some 3500 series LAPs that are not attached to our network.  Will running the following commands via a console session to the AP accomplish this?

clear capwap ap ip address

clear capwap ap ip default-gateway

write memory

reload

or do I just need to clear the private-config file and reboot?  I'd perfer not to do this.

1 REPLY
VIP Purple

Re: Configure LWAP for DCHP via console

Yes, If you just want to delete the static IP address (& leave the controller address learnt by AP as it is) then you can use the below two lines. You cannot do write mem as it is CAPWAP AP.

clear capwap ap ip address

clear capwap ap ip default-gateway

If you do the below, it won't remove statically configured IP, So it won't achieve what you want.

"clear capwap private-config

If you want to delete everything (even previously known controller IP from AP NVRAM) you can do this

AP0026.0b63.caf4#debug capwap console cli

This command is meant only for debugging/troubleshooting

Any configuration change may result in different

behavior from centralized configuration.

CAPWAP console CLI allow/disallow debugging is on

AP0026.0b63.caf4#erase /all nvram:

Erasing the nvram filesystem will remove all files! Continue? [confirm]

[OK]

Erase of nvram: complete

*Mar  1 00:05:19.793: %SYS-7-NV_BLOCK_INIT: Initialized the geometry of nvramoad

AP0026.0b63.caf4#reload

Below reference should be useful on this

https://supportforums.cisco.com/docs/DOC-24917

HTH

Rasika

**** Pls rate all useful responses *****

229
Views
0
Helpful
1
Replies
CreatePlease login to create content