In all the configuration of the wism2 the configure the service port out of the allowed vlans of the trunk facing the wism2 card. i was wondering if I add this vlan to the trunk it should not have any diference since this vlan is for use on the wism.
Well when you do the wism auto command it bundles them in the trunk. Not sure why you would not add the service port inside the trunk. If you have issues and open a TAC case. They could have you change it prior to troubleshooting your problem. Its not normal practice.
__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin __________________________________________________________________________________________ "I'm in a serious relationship with my Wi-Fi. You could say we have a connection."
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...