Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
Sorry, if already asked...
I try to config Wireless on Cisco 878...
I want that switch ports be in one VLAN with Wireless port... and Wireless client be in one ip subnet with LAN clients...
I use following instructions
my config is:
no ip address
bridge-group 1 spanning-disabled
ip address 192.168.0.1 255.255.255.0
BVI int is up, protocol is up but i can't ping 192.168.0.1 not from Wlan and LAN...
What methode can I use to configure router for my task?
Thank you very much...
For this all you need to do is have a single VLAN on the wireless router and configure the switch native vlan as the same vlan as the router. This will work.
Sorry, but can you type recomended commands?