Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Console mode of 1200 series

How do i change the IP address of my AP 1200 access point through console mode ?

i am able to plug in my console cable to see the bootup but i cannot go into config mode to make changes to my configuration.

I need to change the IP address because i want to deploy the AP to another vlan.

2 REPLIES
Silver

Re: Console mode of 1200 series

After you log in to the console type in the following command at the prompt to go into the configuration mode and change the IP address. Remember, for AP the IP address should always be assigned to the BVI interface.

AP# config t

AP# int bvi1

AP# Ip address

For more information read the document available at http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a0080606cbe.html#wp1103336

New Member

Re: Console mode of 1200 series

What version of firmware is in the AP. If you cannot go into config mode, it smells like you have an AP with LWAPP and there is no way to configure a static IP address. Convert to autonomous.

165
Views
0
Helpful
2
Replies