Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Constant disconnection of Wireless Clients

Hi,

I have a Cisco Access Point 1140 Series, and the users has problem when they try connect to the Wireless.

In the console I have these messages:

%DOT11-6-DISASSOC: Interface Dot11Radio0, Deauthenticating Station MAC Reason: Previous authentication no longer valid

%DOT11-6-ASSOC: Interface Dot11Radio0, Station MAC Reassociated KEY_MGMT[WPA PSK]

%DOT11-6-DISASSOC: Interface Dot11Radio0, Deauthenticating Station MAC Reason: Previous authentication no longer valid

%DOT11-6-ASSOC: Interface Dot11Radio0, Station MAC Reassociated KEY_MGMT[WPA PSK]

%DOT11-6-DISASSOC: Interface Dot11Radio0, Deauthenticating Station MAC Reason: Previous authentication no longer valid

%DOT11-6-ASSOC: Interface Dot11Radio0, Station MAC Reassociated KEY_MGMT[WPA PSK]

How I can solve this problem?

10 REPLIES
Hall of Fame Super Silver

Re: Constant disconnection of Wireless Clients

Can you post your show run-config

Also just in case... Seems to be a real issue these days... If your using WPA v2, make sure you only have AES enabled. WPA v1 should only use TKIP.

Also try an open authentication.... See if the client is stable or not. If not, maybe update the driver.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Silver

Re: Constant disconnection of Wireless Clients

First try to connect with open authentication and test it to check if there is any other issue and if that is working then try other option of WPA.

New Member

Constant disconnection of Wireless Clients

Hi friends,

The configuration of the APs was tested in a lab environment and this tests were successful.

The AP configuration has two SSID, with WPA v1 and TKIP.

Silver

Constant disconnection of Wireless Clients

I will try to find the solution by tommorow in the mean time do try to reset the AP to default and try to config agian hopefully it wil resolve the issue if it was working 100% in the test enviroment

Hall of Fame Super Silver

Re: Constant disconnection of Wireless Clients

Post your show run-config.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
New Member

Constant disconnection of Wireless Clients

Scott,

dot11 syslog

dot11 ssid SSID1

   authentication open

   authentication key-management wpa

   wpa-psk ascii 7

dot11 ssid SSID2

   authentication open

   authentication key-management wpa

   wpa-psk ascii 7

crypto pki token default removal timeout 0

bridge irb

interface Dot11Radio0

no ip address

encryption mode ciphers tkip

ssid SSID1

ssid SSID2

antenna gain 0

channel 2412

station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

interface Dot11Radio1

no ip address

encryption mode ciphers tkip

ssid SSID1

ssid SSID2

antenna gain 0

dfs band 3 block

channel dfs

station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

interface GigabitEthernet0

no ip address

duplex auto

speed auto

no keepalive

bridge-group 1

bridge-group 1 spanning-disabled

no bridge-group 1 source-learning

interface BVI1

ip address 10.x.x.y 255.255.255.0

ip default-gateway 10.x.x.y

ip forward-protocol nd

ip http server

no ip http secure-server

New Member

Re: Constant disconnection of Wireless Clients

kindly follow the following step

   In reference to the out put error

  Option 1  : Step the same password to both the SSID and check if you receive the same error

  Option 2. : Do the same config on the single SSID and tst the connectivity .

  Also do reset the AP to default before proceding .If nothing is working try to update the IOS to a stable release .(Final Option) as you will easly resolve it before.

  Also can you share the GUI screen shot while configuring and if the problem is resolve to mention here.

  (if you have used a differet approach do mention)

Important: Make sure you are not using any acl or MAC based authentication or denyed AP association.

Bronze

Re: Constant disconnection of Wireless Clients

in aIOS, by default client is removed if it reaches max retries.

pls first look into your RF enviornment, and interferer or high channel utilization.

then you can add packet retr x [drop] . add drop option to drop the packet and retain the association.

Sent from Cisco Technical Support iPad App

New Member

Re: Constant disconnection of Wireless Clients

wel you are right but its not connecting even the single device (i think) and and this error is closely related to roaming ,power issue and somthing due to ios and hardware problem as nothing related to this sacnario it is being used as a stand alone device i belive .

             your thoughts...... !!!!!         

Regards

Kash

Hall of Fame Super Silver

Re: Constant disconnection of Wireless Clients

Test with an open SSID. That will eliminate any issue with the AP.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
336
Views
0
Helpful
10
Replies