Just to add... WCS/NCS/MSE should either be on equivalent firmware versions or higher (newer) than the WLC firmware version.
If you search the forum, what others have done is to create a WLAN template, one that disables and another that enables the WLAN. Then you can setup the template to run on a schedule. So you would have different templates for the weekdays and for the weekend.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...