Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Convert 3702i to autonomous

Hello All,

 

 

I am looking for the documentation on how to convert a 3702i LWAP into autonomous mode but not having any luck.

 

 

All replies rated.  Thanks in advance!

1 ACCEPTED SOLUTION

Accepted Solutions

Start with the IOS image,

Start with the IOS image, ap3g2-k9w7-tar.152-4.JB5.tar.   Then the Release notes: OL-31714-02 (1) Which says your are out of luck, unless you ONLY want to do Site Survey's with the 3702!

The RN's do also explain how to accomplish the downgrade.(oops wrong, just which ios does what)

If it is linked to the WLC then you can cli the following:

config ap tftp-downgrade tftp-server-address filename access-point-name i.e.:

config ap tftp-downgrade 192.168.1.10 ap3g2-k9w7-tar.152-4.JB5.tar Survey

 You might also find Rasika's guidance to your liking for the manual method:

http://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

 

 

1 REPLY

Start with the IOS image,

Start with the IOS image, ap3g2-k9w7-tar.152-4.JB5.tar.   Then the Release notes: OL-31714-02 (1) Which says your are out of luck, unless you ONLY want to do Site Survey's with the 3702!

The RN's do also explain how to accomplish the downgrade.(oops wrong, just which ios does what)

If it is linked to the WLC then you can cli the following:

config ap tftp-downgrade tftp-server-address filename access-point-name i.e.:

config ap tftp-downgrade 192.168.1.10 ap3g2-k9w7-tar.152-4.JB5.tar Survey

 You might also find Rasika's guidance to your liking for the manual method:

http://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

 

 

5756
Views
0
Helpful
1
Replies
CreatePlease to create content