Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Converted 1130 LAP to Autonomous - not appearing in CNA

Hi,

I have a colleague who accidentially purchased a number of 1130AG LAP access points. They have since converted them to autonomous and can now configure them.

The problem now is that they appear in Cisco Network Assistant as "unknown devices". I am wondering if this is related to CDP reporting them as LAP's. Does anyone have suggestions as to what can be done to resolve this?

Thanks

3 REPLIES
Hall of Fame Super Silver

Re: Converted 1130 LAP to Autonomous - not appearing in CNA

From the release notes, these devices are no supported. AP1100's are though not 1130's.

http://www.cisco.com/en/US/prod/collateral/netmgtsw/ps6504/ps5931/product_data_sheet0900aecd8068820a.html

-Scott
*** Please rate helpful posts ***
Community Member

Re: Converted 1130 LAP to Autonomous - not appearing in CNA

Thanks for your response. They have existing 1130's in CNA but not the 1130 LAP's which were converted to autonomous. I'm still wondering if this is because the CDP information still reporting the model as a LAP?

Hall of Fame Super Silver

Re: Converted 1130 LAP to Autonomous - not appearing in CNA

It most likely might be that. Look at this bug CSCsc68458, mentioned previously that there was an issues with that model.

-Scott
*** Please rate helpful posts ***
234
Views
0
Helpful
3
Replies
CreatePlease to create content