I am trying to migrate from an AP via the WCS and handed me the following log
START: Detailed logging started at -> 09.21.2010_19.12.09
INFO: TELNET to device 172.16.53.103 done. INFO: Privilege level is equal to 15. INFO: Setting vty line completed. INFO: Dumped Environmental variables. INFO: AP is supported for Upgrade process INFO: IOS version is greater than or equal to 12.3(7)JA. INFO: AP has MIC installed already. INFO: Station role is root. INFO: DNS and Domain name configured. INFO: Mac address of device is 00:23:33:97:74:62 INFO: Completed Dot11Radio0 shutting. INFO: Device set up done and time configured on device. INFO: Run-config dumped. INFO: Gateway 172.16.53.1 INFO: Hostname HotelC4 INFO: Dumped Environmental variables. INFO: Starts loading recovery image, takes time based on link speed. ERROR: Device Response :: examining image... %Error opening (Permission denied)archive download: takes 0 seconds ERROR: Image Loading FAILURE. INFO: Un-shut radio 1 done.
END: Migration Process Failure: Image Loading Failure.
The AP is a 1121 and I have the IOS file-C1100-rcvk9w8 tar.124-21a.JA2
tftp server field put the ip address of my PC
in the field file path C:/
in the field file C1100-rcvk9w8 tar.124-21a.JA2
please help need to know that I'm doing wrong step
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...