Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Converting back AP 2600 from Autonomous to LWAPP

Hello,

I have Cisco AP 2600, Previously  i had converted it from  LWAPP mode into Autonomous-Mode.  But now I need to revert it back to LWAPP mode.  

Can anyone send me the link on how to do it ?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: Converting back AP 2600 from Autonomous to LWAPP

HI Imran,

Yes you can convert it to lightweight. Just need the lightweight recovery image.

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html

For the LWAP conversion, use the recovery image (example:  c1140-rcvk9w8-tar.124-25d.JAL.tar). after thatuse the command on the autonomous AP priviledge mode.

AP#archive download-sw /force-reload /overwrite tftp://10.10.10.1/c1140-rcvk9w8-tar.124-25d.JA.tar

more detial ..follow this post:

http://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

Regards

Dont forget to rate helpful posts

1 REPLY
VIP Purple

Re: Converting back AP 2600 from Autonomous to LWAPP

HI Imran,

Yes you can convert it to lightweight. Just need the lightweight recovery image.

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html

For the LWAP conversion, use the recovery image (example:  c1140-rcvk9w8-tar.124-25d.JAL.tar). after thatuse the command on the autonomous AP priviledge mode.

AP#archive download-sw /force-reload /overwrite tftp://10.10.10.1/c1140-rcvk9w8-tar.124-25d.JA.tar

more detial ..follow this post:

http://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

Regards

Dont forget to rate helpful posts

194
Views
0
Helpful
1
Replies
CreatePlease to create content