Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Could power off the Aironet 1130 status LED?

We had a Aironet which needs to installed on dark room but its status LED always blink. Could we turn off the LED by configure? As I knew this AP can be configured continuously blinking the status LED.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Could power off the Aironet 1130 status LED?

There is no way that I know of to turn off the leds. The only hidden command is one that allows you to blink them from the cli and change the duration of each but it will not stop them. Electrical tape over the leds is probably your only option.

3 REPLIES
Red

Re: Could power off the Aironet 1130 status LED?

Access the AP via a browser and go to System Software -> System Configuration

There should be an option there for Blink the Access Point LEDs

Community Member

Re: Could power off the Aironet 1130 status LED?

Thank, that is for LED blink.But, we need to turn off the "Status LED".

Bronze

Re: Could power off the Aironet 1130 status LED?

There is no way that I know of to turn off the leds. The only hidden command is one that allows you to blink them from the cli and change the duration of each but it will not stop them. Electrical tape over the leds is probably your only option.

516
Views
0
Helpful
3
Replies
CreatePlease to create content