Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Anonymous
N/A

Couldn't save configuration on 3602i AP

Error message: NVRAM verification Failed.

I assign a static IP address on the interface BVI1 of WAP 3602i from console connection.

2 REPLIES
VIP Purple

Re: Couldn't save configuration on 3602i AP

Hi ,
I think this is a CAPWAP AP , You Need WLC to use this.

If you are Facing Problem weile connecting to WLC Then paste the output:
From WLC : sh sysinfo
From. AP: sh version

Regards

Sent from Cisco Technical Support iPad App

Hall of Fame Super Silver

Couldn't save configuration on 3602i AP

Typically that might be a hardware issue.  The write memory isn't available on lwapp or capwap, but you will get a different error:

AIR-CAP3602I-A-K9#wr mem

                   ^

% Invalid input detected at '^' marker.

If your AP is autonomous, then look at this link

https://supportforums.cisco.com/docs/DOC-3104

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
290
Views
0
Helpful
2
Replies
CreatePlease to create content