Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Country settings for 1142 AP

If I have these two models connected to 7500,

AIR-CAP3602I-Q-K9 and AIR-LAP1142N-P-K9

I need to enable the

Japan 2(P) - enabled

Japan 4(Q) - enabled

correct?

Reason is I am receiving reports of users not able to connect intermittenly, especially near the 1142 models. They are getting the usual windows message that they cannot connect to the ssid. Sometimes it works.

How do I turn on debug on these few APs? Please help.

1 REPLY
VIP Purple

Country settings for 1142 AP

Hi Jagan,

Yes you rae right, you must enable P, and Q both.

If you want to see the logs then please paste the output of this command:

From WLC:

debug client

Regards

172
Views
0
Helpful
1
Replies