Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debugging/error messages

I'm having trouble getting a laptop to authenticate and I was hoping someone could help me with what debug commands to use on the AP. I've tried a few but I'm not getting anything to show up at the console prompt on the AP. I'm running Windows 2003/IAS/RADIUS with a single AIR-AP1232AG-A-K9. Everything is setup for PEAP (EAP-MSCHAP V2). Any help would be greatly apprecaited. Thanks.

Riley

3 REPLIES
Silver

Re: Debugging/error messages

Enable the command terminal monitor from the previliege mode and then use the debug commands on the access point.

New Member

Re: Debugging/error messages

Thanks for the reply.

I'm new to both Cisco and wireless so I'm not sure exactly what debug commands would be best. I'm not familiar with everything involved in troubleshooting problems with connections/associations and authentications and the radios etc. Would you mind recommending which commands I should use and for what purpose? Thanks.

Hall of Fame Super Silver

Re: Debugging/error messages

Post the errors you see on the IAS serever event viewer. Also post the show log from the AP... just so we can see the errors.

Here is a link to some of the debug commands:

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_10b_JA/command/reference/cr12410b-chap2.html

-Scott
*** Please rate helpful posts ***
157
Views
0
Helpful
3
Replies
CreatePlease login to create content