Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Default SSID Disappears When Additional SSID Added

Hi,

I have an issue when configuring an additional SSID for an autonomous AP, hopefully someone can point me in the right direction.

Currently there is one SSID configured to use VLAN 1, Bridge Group 1, and the normal dot11Radio0 and FastEthernet0 interfaces. I can associate clients to this SSID without issue.

I then configure a second SSID, and assign it to VLAN 253, Bridge Group 253, and sub-interfaces dot11Radio0.253 and FastEthernet0.253. Clients can associtae with this SSID ok, but now clients are unable to associate with the original SSID on vlan 1.

Is there something key that I would have missed or any particular debug commands to run that will narrow down the problem?

APs are Aironet 1230B's running c1200-k9w7-mx.123-7.JA1.

Thanks,

Paul

HTH Paul ****Please rate useful posts****
Everyone's tags (4)
2 REPLIES
Bronze

Re: Default SSID Disappears When Additional SSID Added

Sorted this.

I needed to specify vlan 1 with the encryption methods and ssid, eg:

dot11 ssid wlan1

vlan 1

authentication open eap eap_methods

authentication network-eap eap_methods

int dot11Radio0

encryption vlan 1 key 1 size 128bit 7 1234567890ABCDEF1234567890 transmit-key

encryption vlan 1 mode wep mandatory

Thanks,

Paul

HTH Paul ****Please rate useful posts****

Re: Default SSID Disappears When Additional SSID Added

Are you using MBSSID command? This is the commadn that is needed to broadcast multiple SSIDs.

If not using it, issue the command under the ssid and the radio interfaces.

under the ssid:

mbssid guest-mode.

under the radio:

mbssid.

you may also give a look to this discussion:

https://supportforums.cisco.com/thread/2063707

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"
541
Views
0
Helpful
2
Replies
CreatePlease login to create content