Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Design with WiSM

I plan to have our access points physically connected to the access switches which, in turn, connect to the Distro switches. Where should I install my WiSM modules? Distro or Core? I think it should be at the Core since "all wireless data traffic is tunneled through the controller". Any suggestions? Any Cisco documentations on this?

Thanks

-B

1 REPLY
Hall of Fame Super Silver

Re: Design with WiSM

Here is a good link. It depends if you are running layer 3 to the access, layer 3 just between the distro and the cores switches or just running layer 2 all around.

http://www.cisco.com/en/US/docs/solutions/Enterprise/Mobility/emob41dg/ch2_Arch.html#wp1032226

-Scott
*** Please rate helpful posts ***
141
Views
5
Helpful
1
Replies
CreatePlease to create content