Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
Please how can I configure DHCP on my Wireless Access Point network, so that the client PC's can always Acquire Network Addresses from it when connecting: Please find my config below:
no aaa new-model
dot11 ssid ************
no ip address
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
Thank you all!
You should be able to do it like this:
ip dhcp pool WIRELESS
network 192.168.100.0 255.255.255.0
ip address 192.168.100.1
To exclude addresses from the scope:
ip dhcp exclude 192.168.100.1 192.168.100.99
This would allow 192.168.100.100 - .254 to be assigned.