Well if you console into an access point, you can see if option 43 works because in the output it will show you that the ap learned the WLC address through dhcp. Other than that way, I don't think there is another way.
Since it is an option defined on your DCHP server & provides to AP when it requesting an IP from a DHCP server, you cannot run a command on WLC & get this information. AP console would be the easiest way to see what WLC ip configured in option 43 unless you can see it on DHCP server itself. None of them available then you need to sniff packets when AP is booting up
Once AP complete the WLC hunting process (static, DNS, DHCP option 43,broadcast), it will initiate the AP registration process where it starts to communicate with a WLC (CAPWAP discovery request & response msg). In this CAPWAP discovery request AP indicate from which method (static, DNS, DHCP, broadcast) it learns WLC address (see Message Element Type). You have to sniff packets to see this information & refer below post for more details
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...