I have an Aironet 340 AP that I setup at home connecting to my cable modem (through a Linksys SD216 10/100 switch). The AP gets valid DHCP IP/mask/gateway addresses from my cable modem but while my laptop sees and connects to the AP, it won't get a DHCP address. I've been able to hardwire through the switch so I can run the web interface setup (as well as by console cable and HyperTerminal), but I'm not sure if it's a configuration issue or something else.
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...