Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

DHCP service on AIR-AP1231

Hello everyone

I'll be short

please help me to configure Cisco WiAP AIR-AP1231 to give ip address from this range (192.168.1.2-192.168.1.50) to client devices that are connected through radio interface.

How to configure that in cisco IOS ?

Thank you

4 REPLIES
Silver

Re: DHCP service on AIR-AP1231

APs are not able to serve DHCP to clients any differently than other IOS devices. To do this, you will need to define the DHCP pool on the AP, then if the AP IP is on a different vlan than the users will be, you need to set up an IP helper address on the router pointing to the IP of the AP.

New Member

Re: DHCP service on AIR-AP1231

Thank you

and if I do not use any VLAN ?

then how should I configure my AP to assign class B private IP addresses on client devices on Dot0 interface ?

Thank you again

Silver

Re: DHCP service on AIR-AP1231

If you're not using VLANs, you just need to give your AP an IP in the range you want to assign IPs from, then define the dhcp pool. For example, if you were trying to use 172.60.0.0/16 You would give the AP an IP (172.16.0.2 for innstance) and do the following config:

!exclude first 2 IPs from DHCP

ip dhcp excluded-address 172.16.0.1 172.16.0.2

ip dhcp pool test

network 172.16.0.0 255.255.0.0

default-router 172.16.0.1

dns-server x.x.x.x

New Member

Re: DHCP service on AIR-AP1231

Thank you very much

395
Views
4
Helpful
4
Replies
CreatePlease to create content