Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dial backup for Cisco 350 building-to-building Connection

How is it possible to create with two separate Routers an automatic dialbackup for an wireless bridge link?

The router needs to dial when it somehow discovers a broken wireless link.

Is this possible? What kind of event could trigger the router?

regards

Andre

1 REPLY
Cisco Employee

Re: Dial backup for Cisco 350 building-to-building Connection

Due to the fact you The bridges are connected to an ethernet interface you can not use most dial back up mechanisms.

The best option I have seen is to run a dynamic routing protocol such as EIGRP or OSPF and then use dailer watch features. You will just need to make sure that the route you watch on the remote end of the bridge link can not be seen through another network path until the dial link comes up

156
Views
0
Helpful
1
Replies
CreatePlease login to create content