i have a client they have main office and some 10 branches connected via 1 mbps link .
We put new WLC 5508 in main office (software version 22.214.171.124) and i connected braches 1142 ap's and they registerd with WLC .
Now client have 3 ssid 1> scanners 2>network 3> guest
They want to show same ssid in all branches no single change requried on ssid .
suppose the scanners connecte in main offcie via mac filtering and they will get ip range 192.168.1.0
and when from branch a there they have different range they should get 172.16816.0 range .
the ssid network will be acs authentication and ssid guest will be preshared key . All the ssid ip range will be differnt in branches but they want same ssid . Is it possible.( Can any body give me the steps )
Also one more issue am facing is . in MAIN OFFICE switch vlan 600 for ssid scanners range 192.168.1.0
and in branch same vlan 600 for ssid scanners ip range is 126.96.36.199 . so am getting some error when i save in WLAN SSID enable and save .
If you have local switching enabled for the SSID then you may need to use HREAP groups. You can override the VLAN in each branch office to use a local significant VLAN. You need DHCP server in each bran office for this.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...